Reassessment of myocardIAL Bridge TOwards PeRsOnalized Medicine

TRIAL PROCEDURES Once MB is angiographically detected, eligible and consenting patients will be randomly assigned in a 1:1 ratio to receive a "standard approach" or a "full-physiology approach" during index CA. Index coronary angiography Coronary angiography will be performed through a radial or femoral approach. Unfractionated heparin (initial weight-adjusted intravenous bolus of 50-70 IU/kg, with repeat boluses to achieve an activated clotting time ∼250) will be administered in all patients. To fully expose all segments of the coronary arteries, at least 2 perpendicular projections for the right coronary artery (RCA) and 4 projections for the LAD will be taken. Intracoronary nitrates can be used (depending on blood pressure and, in any case, at the discretion of the Investigator) to increase the angiographic sensitivity in detecting the "milking effect". Physiological epicardial and microvascular assessment MB hemodynamic assessment will be performed using a diagnostic guidewire placed in the index vessel. Intravenous heparin (50-70 U/kg) should be administered to achieve therapeutic anticoagulation (activated clotting time ∼250 s). The innovative Abbott PressureWire™ X Guidewire will be used to measure pressure and temperature. The guidewire's wireless measurements are connected to an advanced platform (Coroventis‡ CoroFlow‡ Cardiovascular System) to measure physiological indices. Abbott's PressureWire™ X Guidewire and Coroventis‡ CoroFlow‡ Cardiovascular System are, nowadays, the only solution for the cath lab able to assess both epicardial vessel (i.e., FFR\< 0.80) and microcirculation (i.e., CFR\< 2.0 and IMR≥ 25). Epicardial assessment will include: * Resting Pd/Pa (n.v. \> 0.92) * FFR after intravenous adenosine administration (n.v. \> 0.80) * RFR (n.v. \> 0.89) * FFR after intravenous dobutamine administration (n.v. \> 0.75) FFR is defined as the mean distal pressure (Pd)/mean aortic pressure (Pa) across MB during maximal hyperemia, achieved by administration of intravenous (140 μg/kg/min) or intracoronary bolus (up to 200 µg) of adenosine. Pd/Pa was automatically calculated by current computational software as the ratio found in the pressure recording. A cut-off of 0.80 will be used to detect hemodynamic relevance. Inotropic stimulation to exalt the hemodynamic significance of MB will be performed with intravenous dobutamine infusion, in case of a negative functional assessment (Pd/Pa\> 0.92, FFR\> 0.80, RFR\> 0.89). The infusion will be started at 5 μg/kg/min and increased by 5μg/kg/min every 5 minutes up to 20 μg/kg/min or until the patient develops symptoms or clear evidence of ischemia. An intravenous infusion of 1 mg atropine will be administered if the patient will not experience symptoms or signs of myocardial ischemia with 20 μg/kg/min of dobutamine infusion. An intravenous bolus of β-blocker (i.e., metoprolol 5 mg) will be administered at the end of the procedure to antagonize the effects of dobutamine. Microvascular assessment will include: * basal CFR (n.v. ≥ 2.0) and CFR after intravenous dobutamine administration (CFR-d) * basal IMR (n.v. \< 25) and IMR after intravenous dobutamine administration (IMR-d) The coronary flow reserve and the microcirculatory resistance will be calculated using thermodilution thanks to the PressureWire™ X Guidewire. The thermodilution-based CFR cut-off value is 2.0. It is the ratio of the maximal or hyperemic flow down a coronary vessel to the resting flow. IMR is calculated as the product of distal coronary pressure at maximal hyperaemia multiplied by the hyperaemic mean transit time. Reduced CFR (\< 2.0) and increased IMR (≥ 25) are representative of structural microvascular dysfunction (impaired endothelium-independent vasodilatation). ACH provocative test In order to unmask MB-related epicardial and/or microvascular CAS, ACH provocative test will be performed in case of absence of epicardial hemodynamic significance and structural microvascular dysfunction. Incremental doses of 20, 50, 100 and 200 μg of ACH will be infused over a period of 2 minutes into the index vessel (vessel with angiographic "milking effect") via the angiographic catheter, repeating CA after each Ach dose. The test will be performed with a continuous monitoring of symptoms, electrocardiogram (ECG), and angiographic evidence of spasm. Angiographic responses during the provocation test will be assessed in multiple orthogonal views to detect the artery spasm. If either complications and/or a positive response occurred, the test will be discontinued, and higher doses will be not administered. The test will be considered positive for epicardial CAS in the presence of focal or diffuse epicardial coronary diameter reduction ≥90% in comparison with the relaxed state following intracoronary nitroglycerine administration given to relieve the spasm, associated with the reproduction of the patient's anginal symptoms and ischemic ECG shifts. Microvascular spasm will be diagnosed when typical ischemic ST-segment changes and angina develop in the absence of epicardial coronary constriction (\< 90% diameter reduction). Patients who will not experience angina, spasm, or ST-segment shifts will be considered to have a negative test response (normal coronary vasoreactivity). Similarly, patients who will experience ischemic ECG shifts without angina or patients with chest pain without ischemic ECG shifts will be considered to have a negative test response. Statistical analysis Statistical analysis will be performed using statistical software package Statistic for Data Analysis Stata 17 (64 bit; StataCorp, College Station, TX) and GraphPad Prism version 8.0.2 (GraphPad Software, San Diego, CA). Chi-square, Fisher's exact test and Kruskal Wallis test will be used to compare categorical variables. Continuous variables were listed as mean ± standard deviation (SD) and will be compared between groups using the Student's t-test, the Mann-Whitney U test, as appropriate. We will perform a 2-tailed analysis and consider a p-value ≤0.05 to be significant. With respect to the primary endpoint, all events occurring from randomization to the study end date will be counted. The number and rate of patients experiencing a primary endpoint will also be summarized. The proportion of patients remaining event-free over time will be displayed in the form of survival curves using the Kaplan-Meier method and analyzed using the log-rank test and the Gehan-Breslow-Wilcoxon test. With respect to secondary endpoints, a Cox proportional hazards model will be used, and estimates of the hazard ratios and their confidence intervals will be provided. In general, missing values will remain as missing, i.e., no attempt will be made to impute missing values and only observed values will be used in data analyses. An interim analysis will be performed on the primary endpoint when 50% of patients will have been randomized and completed the 6 months follow-up. The interim analysis will be performed by an independent statistician, blinded for the treatment allocation.