Biomechanical Validation of the Caregiver Assisted Transfer Technique Instrument

The objective of this study is to further establish the psychometric properties of the CATT and to evaluate the effects of an individualized intervention for participants who have transfer technique deficits as identified by the CATT. Specific Aim 1 (Reliability): Establish the CATT's intra and inter-rater reliability in evaluating the quality of informal caregiver assisted transfer techniques. Hypothesis 1a: Each item and the total score of the CATT will have excellent intra-rater and interrater reliability (ICC \>0.8 for total scores; K\>0.8 for individual item scores). Specific Aim 2 (Validity): Establish the CATT's construct and concurrent validity through relating the scores to caregiver characteristics and to the biomechanical measurement of caregiver techniques. Hypothesis 2a (Construct Validity): Characteristics of the caregiver including younger age, lower levels of shoulder, neck or back pain, better overall health status, higher income, and higher level of education will predict higher scores on the CATT (indicative of better transfer technique). Hypothesis 2b (Concurrent Validity): Higher total CATT scores (indicative of better transfer technique) will correlate with lower peak lumbar forces, less trunk flexion and axial rotation, and greater hip and knee flexion. Specific Aim 3 (Responsiveness): Demonstrate improvement in the quality of assisted transfer technique after individualized training with caregivers who have transfer skill deficits. Hypothesis 3a: After training, participants will demonstrate higher CATT scores, showing improvement in transfer technique. Hypothesis 3b: After training, the biomechanical measures described in Specific Aim 2 will show improvement (e.g., lower peak lumbar forces, less trunk flexion and axial rotation, and greater hip and knee flexion). This study (observational cohort study) will be conducted with a convenience sample of informal caregivers and their care recipients who they transfer. After signing informed consent, all participants will complete a series of baseline questionnaires consisting of their demographic information, health status, quality of life, and pain. After completion of the surveys, several anthropometric measurements of the caregiver will be taken by the research team, including height, weight, length of the foot, shank, thigh, and trunk. Caregiver participants will then be fitted with eight wireless inertial measurement units placed on the their feet, legs, and trunk. They will also be fitted with pressure insoles placed on the inside of their shoes. Participants will be asked to perform transfers from the wheelchair to two surfaces that they normally transfer to during daily living. A variety of surfaces will be made available for participants to transfer, including a bench, a mat table, a commode, a bed, a chair, a wheelchair and a recreational mobility device (hand cycle). Additional surfaces may be provided at the participant's request. If pairs normally use a transfer assist device to facilitate the transfer, assistive technologies will be made available to them so they can complete the transfers in their usual manner (transfer boards and mechanical lifts will be available on site). The participants will be asked to perform four transfers: 1) moving from the wheelchair to the first selected surface, 2) moving from the first selected surface back to their wheelchair, 3) moving from the wheelchair to the second selected surface and 4) moving from the second selected surface back to the wheelchair. During each transfer, three expert raters will watch each transfer and score the version of the CATT that corresponds with the caregiver's transfer method. Participant dyads will be asked to return to the lab, or the research team will return to them between 24 and 72 hours later to perform the transfer portion of the protocol again. This time frame helps to ensure that repeat administration of the CATT is not affected by rater memories of the first assessment. All raters will independently score each complete and incomplete transfer using the CATT. Raters will also be asked to score the video recordings of the transfers at a later date (at least 1 week after the live recordings). Outcome measures including surveys, questionnaires, and CATT scores from raters will be collected and managed using an online survey approved by the VA Pittsburgh Healthcare System. During the transfers, three rehabilitation professionals will rate each transfer using the CATT while biomechanical data are collected using a combined IMU/pressure insole system. A webcam integrated into the Ultium IMU/insole system will also record each transfer to facilitate determination of the specific phases of the transfer process. Participants who were identified as having transfer skill deficits (i.e. scoring a zero on at least two CATT items) in Visit 1 will be asked to participate in a training session during Visit 2 to determine the responsiveness of a CATT-based training protocol. A clinician trained on the CATT will conduct the training session. The clinician will work with the participants to learn and practice the new techniques. They will have an opportunity to practice the techniques until they feel comfortable with performing them. They will be asked to perform a minimum of two transfers to the same surface for the reassessment. A rater who is trained on the CATT but blinded to the biomechanical deficits and training intervention will score the participants using the CATT after training.