RFA Using Combined Bipolar and Monopolar Energy Deliver With Twin Cooled-Wet Electrodes

In the treatment of HCC, local interventional procedures such as transarterial chemo-embolization and RFA are one of the most widely used methods. The probability of complete necrosis is known to be about 50-60% and 80%, respectively, and in a few cases, viable tumors remain, requiring additional treatment. Thus, in the treatment of residual tumors after locoregional intervention, RFA therapy is known as a safe and effective treatment, and in practice, it can be said to be a treatment that is often performed for the treatment of residual viable tumors. Until now, single or alternating monopolar mode and bipolar mode or multi-bipolar mode have been used for the transfer of radio frequency energy. Unipolar mode is used most frequnetly. Currently, in the present application, an alternating monopolar mode using three electrodes (Octopus electrode) and a bipolar mode using two electrodes (Twin cooled wet electrod, RF Medical) have been mainly used. RFA therapy for residual tumors after locoregional intervention has theoretically some limitations. First, it is difficult to deliver a sufficient amount of the high-frequency electrode per hour due to the high electrical resistance of the tissue due to tissue necrosis, fibrosis, and distribution of non-homogeneous tissue after local intervention. Second, the high frequency energy is distributed non-uniformly in the tissue. One of the ways to overcome this is to generate a high heat in the center and periphery of the tumor to be treated, a method of uniformly transmitting a large amount of energy such as high frequency or microwave, or a strategy to improve the thermal conductivity and electrical conductivity. In order to do this, saline is delivered to the high-frequency electrode to improve electrical conductivity, and at the same time, high-frequency energy can be applied to the center of the tumor and the periphery of the tumor if high-frequency energy can be transferred between the electrodes or around the two electrodes installed in the tumor. It can be evenly delivered and the efficiency of heat transfer is improved, which will improve the therapeutic effect of high-frequency heat therapy on residual tumors after local intervention. Recently, Rf Medical in Korea has developed a twin cooled wet (TCW) electrode capable of injecting physiological saline into these high frequency electrodes and has been approved for clinical use under medical insurance. About 30% has been used using a bipolar mode, which has a theoretical advantage to concentrate high-frequency energy between the electrode and the electrode. However, according to the experience in the present application, when the bipolar mode is used, the rate of ablation is very fast and the transmission of high-frequency energy is relatively easy in the center of the tumor, but the transmission of high-frequency energy in the periphery of the tumor is relatively low, resulting in about 30% of tumors. A marginal recurrence or residual tumor was experienced in the margin, and in the last 6 months, bipolar mode and switching monopolar mode were combined to prevent recurrence in the periphery of the tumor, and treatment was performed with the default setting. The result is low recurrence (6 months local recurrence rate of about 15%).