Development of Novel Physiological CMR Methods in Health and Disease

For this study, the investigators will perform comprehensive physiological CMR in healthy volunteers and patients with suspected or known heart disease (coronary artery disease and heart failure). A sub-set of patients will have follow-up scans after they receive treatment to investigate the therapeutic target role of these physiological CMR metrics. Patients who have given informed consent for this research will receive one physiological stress test depending on the clinical context. There will be 5 clinical subgroups to which patients will be recruited to: Group 1. Heart failure with preserved ejection fraction (HFpEF), Group 2. Heart failure with reserved ejection fraction (HFrEF), Group 3. Pulmonary hypertension (PH), Group 4. Acute myocardial infarction (AMI) and Group 5. Suspected but not treated coronary artery disease (sCAD). Patients will be selected in each group by the clinical specialist/research team as per the published guidelines and local protocols - Group 1 and 2 (19), Group 3 (20), Group 4 (21) and Group 5 (22). First 4 groups of patients will receive pre-load increasing stress test (either passive leg raise or equivalent 500mls intravenous fluid challenge depending on the tolerability). This will be done to investigate if increase in pre-load will help unravel subtle dysfunction which is not apparent at euvolemic state. AMI patients may also receive ischaemia testing stress CMR depending on the main clinically question needed to answer. Patients with sCAD will receive clinically relevant pharmacological stress test (dobutamine, adenosine or regadenoson, inhaled nitric oxide) to diagnose ischaemia. Healthy volunteers who have given informed consent will receive matched physiological stress test so that head-on comparison can be made with the relevant patient cohort. The CMR scan protocol will involve minimal breath-holds and will be patient-friendly. This is achieved by using accelerated, advanced cine and late gadolinium enhancement (LGE)-imaging techniques which require fewer breath-holds and shorter scan. All CMR stress studies will be supervised by an Advanced Life Support (ALS) certified doctor. The CMR protocol for healthy volunteers will include the following components (45 minutes): 1. Survey 2. Baseline cine imaging for functional imaging (rest) 3. Tissue characterisation with native T1-mapping (rest) 4. 4D flow CMR (rest) 5. Record blood pressure, heart rate and oxygen saturation 6. Start of physiological stress (increase pre-load or pharmacological stressors) 7. 4D flow CMR (stress, at low-moderate intensity exercise aiming for heart rate up to 110bpm only) 8. Functional cines (stress, at low-moderate intensity exercise aiming for heart rate up to 110bpm only) 9. Record blood pressure, heart rate and oxygen saturation 10. First pass perfusion imaging (only if adenosine/regadenoson used for myocardial hyperaemia) 11. Record blood pressure, heart rate and oxygen saturation 12. Gadolinium contrast injection 13. Early/Late gadolinium enhancement imaging in short-axis 14. Post contrast T1-mapping End of study For patient's receiving clinical CMR scans, the 'bolt-on' stress CMR protocol will include the following components (20-25minutes): 1. 4D flow CMR (rest) 2. Record blood pressure, heart rate and oxygen saturation 3. Start of physiological stress (increase pre-load or pharmacological stressors) 4. 4D flow CMR (stress, at low-moderate intensity exercise aiming for heart rate up to 110bpm only) 5. Functional cines (stress, at low-moderate intensity exercise aiming for heart rate up to 110bpm only) 6. Record blood pressure, heart rate and oxygen saturation 7. First pass perfusion imaging (only if adenosine/regadenoson used for myocardial hyperaemia) 8. Record blood pressure, heart rate and oxygen saturation