Effects of Dual Bronchodilator Treatment on Cardiopulmonary Interactions in COPD

Prospective, proof-of-concept, single-dose study will be conducted using a randomized, double-blind, placebo-controlled, crossover design. Treatment will consist of a single dose of tiotropium 5mcg and olodaterol 5mcg via Respimat (Inspiolto)(TIO/OLO) or placebo; the order of treatment will be randomized. Submaximal cardiopulmonary exercise tests will be performed 1 hour after inhalation of TIO/OLO or placebo. Changes in blood flow index (BFI) measured by near-infrared spectroscopy (NIRS) during exercise will be the primary study endpoint. Written informed consent will be obtained from all participants prior to performing any study related procedures. Participants will complete: 1) an initial visit to determine eligibility for the study; 2) a run-in visit conducted after 2 weeks of stabilization on short-acting bronchodilator therapy to familiarize subjects with the standardized exercise test (submaximal cardiopulmonary exercise tests) to be used in the subsequent treatment visits; and 3) two treatment visits, randomized to order, conducted 3-7 days apart. Visit 1 will include: 1. A thorough medical history; 2. Clinical assessment; 3. Chronic activity-related dyspnea evaluation; 4. Complete pulmonary function testing; 5. A symptom-limited incremental exercise test on a cycle ergometer to determine maximal exercise capacity (Wmax); and 6. Post-salbutamol pulmonary function testing for assessment of bronchodilator responsiveness. Visit 2 will consist of discontinuous submaximal cardiopulmonary exercise testing for familiarization. Visits 3 and 4 will consist of pulmonary function tests (spirometry, plethysmography), followed by administration of TIO/OLO or placebo. One hour after inhalation, subjects will perform pulmonary function tests (spirometry, plethysmography) followed immediately by the submaximal cardiopulmonary exercise tests. Procedures Pulmonary function testing: Routine spirometry, body plethysmography, single-breath diffusing capacity of the lung for carbon monoxide (DLCO), and maximum inspiratory/expiratory mouth pressures will be performed according to recommended techniques using automatic equipment (Vmax 229d with Vs62j body plethysmograph; SensorMedics, Yorba Linda, CA). Measurements will be expressed as % of predicted normal values. Cardiopulmonary exercise testing: Exercise tests will be conducted on an electronically-braked cycle ergometer using a cardiopulmonary exercise testing system (Vmax229d; SensorMedics) in accordance with clinical exercise testing guidelines. Incremental exercise testing at Visit 1 will consist of a steady-state resting period, followed by followed by 1 minute of loadless pedalling, then 10 watt increases in work-rate every minute to the point of symptom-limitation. Maximal work rate (Wmax) will be defined as the highest work rate that the subject is able to maintain for at least 30 seconds. Constant work rate testing will be conducted at all subsequent visits (see below). Measurements will be collected at rest and during exercise while subjects breathe through a mouthpiece and a low-resistance flow transducer with nasal passages occluded by a noseclip. Measurements will include: standard cardiorespiratory, metabolic and breathing pattern parameters collected on a breath-by-breath basis and compared with predicted normal values based on age and height; heart rate by 12-lead electrocardiogram; blood pressure by auscultation; dynamic operating lung volumes derived from IC maneuvers; oxygen saturation (SpO2) by pulse oximetry; arterialized blood gases from earlobe samples; the intensity of perceived leg discomfort and exertional dyspnea rated by the modified 10-point Borg scale. Breath-by-breath measurements will be averaged every 20-seconds throughout exercise. Three main time points will also be evaluated: rest will be defined as the steady-state period after at least 3 minutes of breathing on the mouthpiece while seated at rest on the cycle ergometer before exercise starts (cardiopulmonary parameters will be averaged over the last 20-sec of this period and resting ICs will be collected while breathing on the same circuit immediately after completion of the quiet breathing period); isotime will be defined as the longest duration achieved during all constant load exercise tests, and; end-exercise will be defined as the last 30-sec of loaded pedaling at the 75%Wmax stage (i.e., Tlim). Submaximal cardiopulmonary exercise tests: constant work rate testing will consist of a steady-state resting period, followed by two stages at unloaded exercise for 5 min and 75% of Wmax to the limit of tolerance (Tlim. min). Cardiac output and muscle blood flow and deoxygenation: Cardiac output will be assessed continuously by a calibrated signal-morphology impedance cardiography system (PhysioFlow; Manatec Biomedical, France). Near-infrared spectroscopy (NIRS; OxyMon MK III, Artinis Medical Systems, The Netherlands) will be used to evaluate skeletal muscle blood flow and deoxygenation. The optode will be placed laterally over the mid-third of the right vastus lateralis. Deoxy-hemoglobin (HHb) has been selected as a proxy for muscle fractional O2 extraction and expressed relative to maximum values elicited by cuff-induced ischemia. The NIRS system measures indocyanine green (ICG) concentration following a bolus injection of 5 mg of ICG into a forearm vein. ICG injections will be performed during the fourth minute of each exercise stage (unloaded and 75%of maximal work load). Symptom evaluation. Dyspnea (respiratory discomfort) will be defined as the "sensation of breathing discomfort" and leg discomfort as "the sensation of leg discomfort experienced during pedalling." These sensations will be rated at rest, every minute during exercise and at end-exercise using the modified 10-point Borg scale. Upon exercise cessation, subjects will be asked to verbalize their main reason for stopping exercise, i.e., breathing discomfort, leg discomfort, combination of breathing and leg discomfort or some other reason to be specified.