Effect of Healing Time on New Bone Formation Following Tooth Extraction and Ridge Preservation With Demineralized Freeze-Dried Bone Allograft

The purpose of this study is to compare healing following tooth extraction and ridge preservation with DFDBA at a healing time point 8-10 weeks after treatment compared to a healing time point 18-20 weeks after treatment. There have been no studies to determine differences in new bone formation using DFDBA for this purpose at various healing time points post-grafting. The primary objective is to histologically determine the amount of new bone formation and residual graft material present at the two healing time points after grafting with DFDBA. Histologic healing will be compared based on three criteria: % of new vital bone formation, % of residual graft material, and % of nonmineralized connective tissue/bone marrow. The null hypothesis is that there will be no difference between the % new bone formation at 8-10 weeks after grafting compared to 18-20 weeks after grafting. This entire protocol involves procedures that are standard care. There will be two subject groups in this study. All subjects will require extraction of a non-molar tooth, followed by replacement of the missing tooth with a dental implant. In order to ensure that the bone core removed during implant osteotomy preparation is taken totally within the confines of the former tooth socket, the tooth to be extracted will have a position and angulation that is the same as the implant that will replace the tooth. Each group will have 22 subjects. Only one tooth will be evaluated in any given subject. Both groups will consist of subjects who will have cortical DFDBA grafted into the extraction socket for ridge preservation following tooth extraction. Group 1 will have a biopsy core taken at the time of implant placement 8-10 weeks after socket grafting. Group 2 will have a biopsy core taken at the time of implant placement 18-20 weeks after socket grafting. Allocation of subjects into group 1 or 2 will based on randomization once enrolled into the study. Subjects will be asked to draw a sealed envelope out of a stack of envelopes, each containing a single slip of paper coded with #1 or a #2. This will determine the treatment group. All of the bone graft materials used in this study will come from the same donor (LifeNet Health). The materials will be procured and processed in the same manner and will have the same particle size and percent residual calcium. This greatly decreases potential variability inherent in bone taken from different donors or processed in different manners. At the time of subject enrollment, the following standard care procedures will be performed: Impressions will be made for fabrication of diagnostic casts and radiographs will be taken of the tooth to be extracted. A clear measurement stent will be made on the cast for vertical and horizontal ridge dimensions. Following local anesthesia, the tooth will be extracted, and the number of bony walls in each socket will be recorded, along with the presence of any bony dehiscences or fenestrations. After extraction, the measurement stent will be placed and a hole will be made in the occlusal surface directly over the buccal bony wall and the lingual bony wall. Holes will be made in the buccal and lingual flanges of the measurement stent at a level approximately 3mm from the bony crests and ridge calipers will be used to make a horizontal ridge width measurement. These measurements will be recorded. The socket will be thoroughly debrided, a 1.0cc bottle of cortical DFDBA will be hydrated with sterile saline and the DFDBA will be placed in the socket to restore the ridge to appropriate contour. A collagen barrier (Collatape or Collaplug) will then be placed over the socket orifice and secured with sutures. Flaps will not be reflected to obtain primary closure. If a large dehiscence exists following extraction, which would most likely affect the facial socket wall, a collagen barrier with a longer resorption time, such as the Zimmer collagen socket repair membrane or BioGide collagen membrane will be used instead of Collatape or Collaplug. As part of standard care, patients will be prescribed systemic doxycycline 100mg twice a day for 7 days after surgery (if patient has sensitivity to doxycycline, alternate will be amoxicillin 500mg three times a day for 7 days). The patient will be seen 7-10 days after extraction/ridge preservation to assess healing, and again 1 month after the procedure. The implant will be placed 8-10 weeks after ridge preservation in Group 1 and 18-20 weeks after ridge preservation in Group 2. At the time of implant placement, the first osteotomy will be prepared using a hollow trephine drill instead of a solid drill. Use of a hollow trephine allows retention of the bony core; whereas, use of solid drills results in removal of the bone in very small particles that cannot be examined histologically. Drilling of the pilot implant osteotomy has historically been done both ways (trephine drill or solid drill). The bone core in the trephine will be removed from the trephine, placed in 10% formalin, and prepared for histologic examination. The study will end immediately after removal of the trephined bone core. Following initial preparation of the implant site with the trephine, the osteotomy will be completed and an implant of the appropriate length and diameter will be placed. The size of the implant will be such that it will engage not only newly formed bone in the socket itself, but at least 2-3mm of bone apical to the former socket site. A healing abutment will then be placed. All subjects will be examined at 7-10 days and 1 month following implant placement. The patient will then be referred to their restorative dentist for final restoration. The histologic cores will be processed for demineralized sections and will be stained. The following histologic parameters will be measured: percent new bone formation, percent residual graft material, and percent connective tissue/other.