Full Occlusal Rehabilitation for Patients With Severe Tooth Wear Using Indirect Composite Restorations

Standard dental treatment will be provided to the patients with severely worn dentitions. Treatment is based on the principles of 'minimally invasive treatment techniques'. Main difference with the 'standard' treatment protocol and the standard procedure of placing composite restorations is the fully digital workflow. In the traditional workflow a silicon impression is made, after which the dental technician produces the (indirect) composite restorations in by hand. These restorations are then adhesively cemented on the teeth by the dentist. In the fully digital workflow, digital 3D-scans are made using the 3D LAVA scanner (3M ESPE). Based on these digital 3D-images a digital wax-up is made by the dental technician after which all composite restorations (uplays and backings) are designed digitally before being milled and finally adhesively cemented on the teeth by the dentists. An important benefit for the patients is the rehabilitation of their worn dentitions. Functionality (teeth are less sensitive, improved chewing ability, a better occlusal stability, etc) and aesthetics will be improved immediately after finishing the treatment. Moreover, the estimated treatment time will be less (estimated treatment time approx. 12hours) than the traditional methods when using the standard treatment protocol (estimated treatment time approx. 18hours). Another potential benefit is a better control and more predictable results by using 3D-images with the pre-designed computer simulation. A risk of these indirect composite resin restorations is the unknown survival rate compared to other indirect as well as to direct application technique